Hide Filters
Filters 0
Sort by :
Filters 0
Kid's Waterproof Sailing Jacket 100 - Navy



Kid's Waterproof Sailing Jacket 100 - Navy

VAT included
Colour :
Size :
Not available online

Store Availability

Our designers—and fellow sailors—developed this waterproof sailing jacket for sailing in warm and stormy weather.



Tested in moderate rain over 2 hrs
15,000 mm Schmerber
Pockets not waterproof


Very breathable coated fabric (RET < 12): reduces condensation


2 secure pockets


Fabric specially coated to reduce the cooling effect of the wind

Water repellent

Specially treated so water slides off the fabric surface.

Salt water resistant

Materials and zips resistant to salt water and sea air.

Compact design

This compact vest can be folded away into a pocket


Waterproofing 1/2

We measure the resistance of a fabric to water pressure expressed in mm of water column (based on the ISO 811 standard). The higher the water pressure withstood by the fabric, the more waterproof it is.
Here are the waterproofing ratings:
Component resistant to water pressure of 15,000 mm before and after ageing (5 washes). This equates to 15 000 Schmerber - average pressure exerted by the water during rain.
The jacket's waterproofing has been tested in a rain shower with 60 litres of water / m² / hour for 2 hours

Waterproofing 2/2

- High collar
- Injection-moulded plastic to avoid salt oxidation
- Water-repellent components (water runs off the fabric)
-100% taped seams
- Central opening features a flap with a drainage channel for optimal waterproofing


The hood does not pack down into the collar, it is attached.
Hood is fully depth-adjustable but not in length. Due to regulations we cannot put an adjustment cord near the neck.
Visor with a headband to provide a good level of protection and a better hold.
The high neck effectively protects the neck.


Two zip pockets on the front of the jacket for your hands or some items
NOTE: the pockets are NOT WATERPROOF

Front zip closure

Using zip on the entire anorak length with an interior flap that protects against the wind and water.
Soft fabric flap on the top of the collar to protect the chin.

Fabric breathability

To find out whether a fabric is breathable, we test its evaporate resistance or RET (ISO 11092 standard). The lower the fabric's resistance, the more moisture is evaporated, and therefore the higher the fabric's breathability.
We consider that if:
RET < 9 = very breathable fabric
9 < RET < 12 = breathable fabric.
The values for the Trek 500 jacket’s breathability are as follows:
> more resistant fabric: RET < 12 (or 3621 g/m²/24h, JIS1099A standard)
> Lightest fabric: RET < 8 (or 2972 g/m² /2

Water-repellent properties information

A fabric is water-repellent when water slides off the surface of the fabric, without seeping in.
Your anorak does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered.
The water-repellent properties can be reactivated by putting the jacket in a dryer for 10 minutes at the lowest temperature.

How to wash your anorak?

To maintain the water repellent properties, infrequent washing is recommended.
Close all zips and flaps, empty all pockets and then turn the garment inside out to wash it. You can wash it on a synthetic cycle at 30°C or 40°C with your usual detergent. Do not use fabric softener, which could damage the existing performance of the garment, or bleach.
Very important: choose a full rinse cycle or extra rinse.


Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your anorak flat on a clothes rack and leave it out to dry in the open. Caution: never dry your anorak directly on a radiator.Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.

Tips for storage and maintenance

Machine wash - 86°F normal cycle
Do not use bleach
Tumble dry low heat
Do not iron
Do not dry-clean



2 Years