Kids’ sailing jacket, warm and waterproof, sailing 100, navy blue / blue
The warm sailing jacket to choose for occasional sailing in cold weather in calm to moderate conditions (moderate wind and rain, calm seas)
This warm kids’ sailing jacket is made from a supple, waterproof fabric for protection from the rain, cold and wind when sailing.
BENEFITS
Resistance to salt water
Materials and zips resistant to salt water and sea air.
Warmth
Quilted lining (150 g/m2 body, 80 g/m2 arms) providing very good insulation
Windproof
High neck, coated fabric and cuff to reduce the windchill effect
Waterproof
Validated 2hrs in moderate rain 100% taped seams 5,000 mm Schmerber
Pockets
3 secure pockets, including 1 inner pocket
Breathability
Very breathable coated fabric (RET < 12): reduces condensation
TECHNICAL INFORMATIONS
Waterproofing
The anorak’s waterproofness was tested in a rain shower with 60 litres of water/m²/hour for 2 hours.
100% waterproof seams, non-waterproof pockets
Component resistant to 5,000 mm water pressure. This equates to 5,000 Schmerber - average pressure exerted by the water during rain.
We measure the resistance of a fabric to water pressure in mm of water column (based on ISO 811 ). The higher the water pressure withstood by the fabric, the more waterproof it is.
Water-repellent properties information
A fabric is water-repellent when water slides off the surface of the fabric, without seeping in.
Your jacket does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered.
The water-repellent properties can be reactivated by putting the jacket in a dryer for 10 minutes at the lowest temperature.
How important is windproofing?
Protection from the wind is critical, as wind can chill the body significantly whether you are active or at rest. According to the "Windchill" model which measures the temperature felt depending on the wind and cold: at a temperature of 5°C combined with winds of 30 km/h, the temperature felt will be 0°C. If the air temperature is 0°C and wind speed is 40 km/h, the temperature felt will be -7°C. Your 100 warm jacket counters the windchill effect.
How to wash your jacket?
To maintain the water repellent properties, infrequent washing is recommended.
Close all zips and flaps, empty all pockets and then turn the garment inside out to wash it. You can wash it on a synthetic cycle at 30°C or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach. Very important: choose a full rinse cycle or extra rinse.
How to reactivate the jacket’s water repellency
Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.
Then put them in the tumble dryer on a short synthetics cycle, i.e., 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.
COMPOSITION
composition
Padding: 100.0% Polyester; Main fabric - Bottom: 100.0% Polyamide; Lining: 100.0% Polyester; Main fabric - Top: 100.0% Polyester; Coating: 100.0% Polyurethane
Tips for storage and maintenance
MAXIMUM WASHING TEMPERATURE 30°C. NORMAL TREATMENT.
BLEACHING EXCLUDED.
DRYING IN TUMBLE DRYER POSSIBLE. LOW TEMPERATURE, MAXIMUM DRUM EXHAUST TEMPERATURE 60°C.
DO NOT IRON.
DO NOT DRY CLEAN.
Storage tips
Store in a dry place, but do not leave your garment on a heat source such as a radiator, as this may damage the coating.
TESTS AND WARRANTY
Warranty
2 Years
Ecodesign approach
With ecodesign, we reduce the environmental impact of our products.
Analysing the product's environmental footprint enabled us to identify the most impactful stages of its life cycle. Thanks to this approach, our design teams were able to develop this product while significantly reducing its environmental impact.
Ecodesign actions on this product
-
ProcessDope dyed
Product made from 32% dope dyed yarn
Using this mass-dyeing process enables us to reduce CO2 emissions linked to the production of dyed textiles by at least 17% compared to conventional dyeing.
-
MaterialRecycled polyester
Product made from 38% recycled polyester
Using recycled polyester rather than conventional polyester reduces the CO2 emissions linked to the material by at least 17%.